SYSTEM: FIBERSHIELD® | MODEL: FIBERSEAL

Type	Smoke protection closure of textile construction or non-thermally insulating fire and smoke protection closure
Verification	CE identification pursuant to EN 16034:2014 in conjunction with EN 13241:2003+A2:2016
Closing direction	From top to bottom
Fire resistance	E 0 – EW 120 | tested in compliance with EN 1634-1:2014+A1:2018 | Classified according to EN 13501-2:2016
Smoke protection	Sa, S200 | tested in compliance with EN 1634-3:2005-01 | classified according to EN 13501-2:2016
Closing cycles	C, C1, C2 | tested in compliance with EN 12605:2000-08 and EN 12604:2017-12 | classified according to EN 13501-2:2016
Fire behaviour of the fabric	A2-s1, d0; B-s1, d0; E-d2 | tested in compliance with ISO 1716 and EN 13823 or ISO 11295-2 | classified according to EN 13501-1:2018
Environment conditions	Special environmental conditions are not taken into account (e.g. humidity > 80 %, ambient temperature < 5 °C and > 45 °C, wind loads etc.)
Visible surfaces	galvanized, RAL - smooth - silk gloss - standard shade, NCS - standard shade

Structural system design (system drawing)

The combination of classifications or the ratio of clear system width to clear system height may reduce the stated maximum dimensions and the dimensions of the housing and guide rails may vary. The specifications on the quotation apply.

Classification	Size max* [y x r] in mm	Fabric	Wall thickness** in mm	Housing	Guide rail
E 120	8792 x 5000	Heliotex	175	Type B, C, D, E	Type 1, 2
EW 90	8792 x 6000	Heliotex	155	Type B, C, D, E	Type 1, 2
EW 120	4340 x 2700	Heliotex	175	Type B, C, D, E	Type 1, 2
C2	7500 x 5000	Heliotex
Sa ***	103,6 m	Protex 600 2S	150	Type B, C, D	Type 1, 2
Sa ***	117,2 m	Protex 1100 2S	150	Type B, C, D	Type 1, 2
Sa ***	76,8 m	Heliotex	150	Type B, C, D, E	Type 1, 2
S200 ****	Fläche 25,2 m2 Fugenlänge von 20,1 ,	Protex 600 2S Protex 1100 2S Heliotex

The installation situation must comply with the building code requirements of the country of installation. The fire resistance of a ceiling or wall support structure and the adjacent components must at least correspond to that of the fire and/or smoke protection closure, fire and/or smoke protection curtain. Evidence of the stability and serviceability of the adjacent walls and structural components must be provided under general ambient conditions and in the event of fire. See also notes on standard supporting structure in EN1366-7:2004 and EN1363-1:2020 respectively. The fire protection system must not be subjected to any additional load other than its own weight, even in the event of fire.
* deviations from size dimensions on request
** tested wall types according to the installation instructions
*** the length of the joint (normative: 3-sided without end strip) must not be exceeded
**** the area and joint length (normative: 4-sided) must not be exceeded

Housing

Guide rails

Note: Dotted line for the winding shaft receptacle (housing)